×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Factory Default Reset on RVL200 VPN Routers

Document

Sat, 07/09/2016 - 13:10
Apr 26th, 2016
User Badges:

Cisco Support Community

Article ID: 1544

Objective

In certain situations, it is desirable to restore the router configuration to the original default factory settings. This is useful when you want to remove an undesirable configuration that is present in the router. If you have configured a router and the configuration has become very complex or if you want to move a router from one network to other, you can reset the router to factory defaults and configure it as a new router. This document provides information on how to restore RVL200 VPN router to its factory default settings.

Applicable Device

• RVL200

Reset Router to Factory Defaults

Step 1. Use the Router configuration Utility to choose System Management > Factory Default. The Factory Default page opens.

 

Step 2. Click Return to Factory Default Setting in order to restore the router to its factory default settings. The confirmation message appears.

Step 3. Click OK to proceed to restore the default settings.

Loading.

Actions

This Document