×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Gateway to Gateway VPN Tunnel using Static IP address on WRV200 Remote Gateway

Document

Sat, 07/09/2016 - 06:10
Apr 26th, 2016
User Badges:

Cisco Support Community

Article ID: 811

Objectives

Virtual Private Network (VPN) is a network thats allows users outside a particular network to be connected to the network as if they are physically present on the same network. VPN allows  to establish a a private connections through public networks like internet.

This document allows to configure IPSec VPN tunnel between two VPN enabled routers when the remote Gateway uses a Static IP Address.

For this document we assume our second router is RV082 and our remote gateway has a Static IP address.

Applicable Devices

• WRV200 Wireless-G VPN Router with RangeBooster.

Configuration of WRV200 when the remote Gateway Uses a Static IP Address

Step 1. Using Web-based Setup page for the WRV200, choose VPN > IPSec VPN.

Step 2. Select the entry you want to configure from the Tunnel Entry drop-down menu.

Step 3. To enable VPN, click Enabled.

Step 4. Enter the name in the Tunnel Name field.

Step 5. Under Local Secure Group, choose Subnet from the Type drop down menu. 

Step 6. Enter the WRV200's local network settings in the IP Address and Mask fields.

Step 7. Under Remote Secure Group, choose Subnet from Type drop-down menu.

Step 8. Enter the RV082's local network settings in the IP Address and Mask fields.

Step 9. Under Key Management, choose appropriate encryption, authentication and other key management settings.

Step 10. In the Pre-shared key field, enter a string for this key, for example test123.

Step 11. Click Save Settings. 

Step 12. First router has been configured.

Step 13. For RV082, Using Web-based setup choose VPN > Gateway to Gateway.

Step 14. Enter a name in the Tunnel Name field.

Step 15. For VPN Tunnel setting, click Enabled.

Step 16. The WAN IP address will be automatically detected and displayed.

Step 17. Select Subnet under Local Security Group drop-down menu.

Step 18. Enter the RV082's local network settings in the IP Address and Mask fields.

Step 19. Under Remote Group Setup, select IP Only from Remote Security Gateway Type drop-down menu.

Step 20. Enter the WRV200's WAN IP address in the IP Address field.

Step 21. Select Subnet from Remote Security Group Type drop-down menu.

Step 22. Enter the WRV200's local network settings in the IP Address and Mask fields.

Step 23. Under IPSec Setup, choose encryption, authentication and other key management settings similar to WRV200's settings.

Step 23. In the Pre-shared key field, enter a string for this key, for example test123.

Step 24. Click Save Settings.

Step 25. To verify connectivity try to Ping a computer from one network to the other network.

 

Loading.

Actions

This Document