×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Session Timeout on RV180 and RV180W

Document

Fri, 07/08/2016 - 19:40
Apr 26th, 2016
User Badges:

Cisco Support Community

Article ID: 1973

Objective

This article explains how to set the timeout value for a user's session on RV180 and RV180W routers.

Applicable Devices

• RV180 VPN Router
• RV180W Wireless-N Multifunction Router

To Set Session Timeout Value

Step 1. Use the Configuration Utility of the router to choose Administration > Management Interface > Session Timeout which opens the Session Timeout page.

Step 2.  To set the maximum number of minutes of inactivity before the Administrator's session is ended, enter the number of minutes in Administrator Inactivity Timeout field. Default Value is 10.

Step 3.  To set the maximum number of minutes of inactivity before the Guest's session is ended, enter the number of minutes in Guest Inactivity Timeout field. Default value is 10.

Step 4.  Click Save to save the settings or click Cancel to revert the changes made.

Loading.

Actions

This Document