×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

WAN Configuration with Automatic Configuration-DHCP Type on RV180 AND RV180W

Document

Sat, 07/09/2016 - 08:10
Apr 26th, 2016
User Badges:

Cisco Support Community

Article ID: 2130

Objectives

This article explains how to configure a Automatic Dynamic Host Configuration Protocol (DHCP) on RV180 and RV180W.

Applicable Devices

• RV180
• RV180W

Steps of Procedure

Step 1. Use the router configuration utility to choose Networking > WAN(Internet) > IPv4 WAN (internet). The IPv4 WAN (internet) page opens.

Step 2. Choose the Automatic Configuration - DHCP option from the Internet Connection Type drop-down menu.

Note: To have the router automatically get its IP address from your ISP’s DHCP server, leave the connection type at its default setting of Automatic Configuration - DHCP Server. Most cable modem ISPs use the default option.

Step 3. Choose the MTU Type.

• Default— Default value is 1500 Bytes.

• Custom— Custom enable you to enter a custom MTU size(bytes) value in the MTU Size field.

Step 4. Choose the MAC Address Source from the drop-down list.

• Use Default Address— Uses the defaults MAC address.

• Use This Computer's Address— Uses the MAC address your computer currently has.

• Use this MAC— Allows you to enter a specific MAC Address.

Step 5. Click Save to save the changes.

Loading.

Actions

This Document