×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Network Mode Change on WVC210 Internet Camera

Document

Fri, 07/08/2016 - 04:40
Apr 26th, 2016
User Badges:

Cisco Support Community

Article ID: 1121

Objective

This Article describes how to Change the Network Mode of WVC210 Camera from Wired Network to Wireless Network & Wireless Network to Wired Network.

Applicable Devices

WVC210 Wireless-G PTZ Internet Video Camera

Step-by-Step Procedure

Wired Network to Wireless Network

Step 1. Unplug the power adapter from the camera.

Step 2. Unplug the Ethernet network cable from the camera.

Step 3. Connect the power adapter again to the power port on the camera.

Step 4. The Camera is ready to use when the Ready and Wireless LED'S are solidly lit.

Wireless Network to Wired Network

Step 1. Unplug the Camera's power adapter from the camera.

Step 2. Connect one end of the Ethernet network cable to camera and other end to the PC or Router.

Step 3. Reconnect the power adapter to the power port on the camera.

Step 4. The Camera is ready to use when the Ready and Wireless LED'S are solidly lit.

NOTE: Power OFF the camera before it is changed from Wireless network to Wired network or Wired network to Wireless network.

Loading.

Actions

This Document