We got FAB-2 (N7K-C7010-FAB-2) with quite an old EPLD .004, and decided to upgrade to a newer version to ensure it operates properly in SUP2 and F3 environment. However the upgrade procedure keeps failing with the messages below. Should I assume the hardware is faulty ?
switch# install xbar-module 1 epld bootflash:n7000-s1-epld.6.0.1.img
Copy complete, now saving to disk (please wait)...
Retrieving EPLD versions... Please wait.
Images will be upgraded according to following table:
Module Type EPLD Running-Version New-Version Upg-Required
------ ---- ------------- --------------- ----------- ------------
1 Xbar Power Manager 0.004 0.006 Yes
Xbar Module 1 will be powered down.
2008 Dec 28 21:16:06 switch %$ VDC-1 %$ %PLATFORM-2-XBAR_DETECT: Xbar 1 detected (Serial number JAF1522AARL)
2 EPLD upgrade failed. Exiting..
Failure reason: Programming failed while upgrading the FPGA. (Error Number : 1)
Images will be upgraded according to following table:
Module Type EPLD Running-Version New-Version Upg-Required
------ ---- ------------- --------------- ----------- ------------
6 SUP Power Manager 3.009 3.009 No
6 SUP IO 3.028 3.028 No
6 SUP Inband 1.008 1.008 No
6 SUP Local Bus CPLD 3.000 3.000 No
6 SUP CMP CPLD 6.000 6.000 No
1 Xbar Power Manager 0.004 0.006 Yes
1 FAN Fan Controller (1) 0.007 0.007 No
1 FAN Fan Controller (2) 0.007 0.007 No
2 FAN Fan Controller (1) 0.007 0.007 No
2 FAN Fan Controller (2) 0.007 0.007 No
3 FAN Fan Controller (1) 0.007 0.007 No
3 FAN Fan Controller (2) 0.007 0.007 No
4 FAN Fan Controller (1) 0.007 0.007 No
4 FAN Fan Controller (2) 0.007 0.007 No
The above modules require upgrade.
Starting Xbar Module 1 EPLD Upgrade
2008 Dec 28 21:18:32 switch %$ VDC-1 %$ %PLATFORM-2-XBAR_DETECT: Xbar 1 detected (Serial number JAF1522AARL)
2 EPLD upgrade failed. Exiting..
Failure reason: Programming failed while upgrading the FPGA. (Error Number : 1)
EPLD Upgrade Completed.
Module Type Upgrade-Result
------ ---- --------------
1 Xbar Failed
