How to assign an IP address to a Wireless Bridge


Nov 18, 2009 6:21 PM
Jun 22nd, 2009


The default IP address for the wireless bridge is To assign a static IP address to a wireless bridge, refer to these documents:

Note: When connecting the PC to the bridge or reconnecting the PC to the wired LAN, it may be necessary to release and renew the IP address on the PC. On most PCs, a release and renew can be performed through a PC reboot. To do this, the ipconfig /release and ipconfig /renew commands can be issued in a Command Prompt window. For detailed instructions, consult the PC operating instructions.

Problem Type

Cannot console or telnet or GUI into a device since the device does not have an IP address



Overall Rating: 0 (0 ratings)


Login or Register to take actions

This Document

Posted June 22, 2009 at 3:33 PM
Updated November 18, 2009 at 6:21 PM
Comments:0 Overall Rating:0
Views:694 Contributors:0

Related Content


Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode