×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Agents have Call Park and transfer issues after parking the first call

Document

Wed, 07/22/2009 - 19:31
Jun 22nd, 2009
User Badges:
  • Gold, 750 points or more

Core Issue

Interactive Call Distribution (ICD) agents can not park their second customer after they park their first customer. They cannot park, transfer or hold the call. When they press the More button, no softkey options for these features show up.


Resolution

This problem is observed because the line runs out of virtual lines. A line can have only two virtual lines active at the same time. When a call is on hold or parked, another line is required to transfer or park subsequent calls. Since the line is occupied by the first call, the transfer and park options will not show up.

To avoid this situation, have another internal normal Dialed Number (DN) assigned    to one of the lines of the agent's IP phone. Have the agent perform the following steps:


  1. Press Transfer.
  2. Enter the number of your internal line, not the ICD line.
  3. Press Transfer again before it connects.
  4. Answer the ringing line. Press the Line button or answer.
  5. Press Park.

Note: Call Park is supported only in CRS 3.x. If Call Park is attempted    in some of the Customer Response Applications (CRA) 2.x versions, it may leave the agents in Stuck In-Session state. For more information, refer to Cisco bug ID CSCdu41417.

Loading.

Actions

This Document

Related Content