cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
19216
Views
19
Helpful
5
Comments
Kapil Atrish
Level 3
Level 3

This document covers some of the troubleshooting steps which may be helpful to confirm if the DTMF is being received on the voice gateway from Telco or not.

Note: In case of ISDN PRI, the Telco doesn’t send DTMF digits but Tone for every digit pressed by the caller. It’s up to the voice gateway to recognize the Tone and convert it into the appropriate DTMF digit.

Comments
shivkumar gadad
Level 1
Level 1

Hi Kapil,

That was really good document.

Thank & Regards,

Shiv

Kapil Atrish
Level 3
Level 3

Shiva, thanks man. How would you rate this doc... ???

shivkumar gadad
Level 1
Level 1

Kapil Bhai,

I did rate for the doc 5/5 ***** 

tgautam
Cisco Employee
Cisco Employee

Great Doc. Does it work for outbound calls? i.e. endpoint-->cucm-->sip-->VG-->PRI. 

For me it didn't show dtmf on outbound calls. Any suggestion?

I was able to see dtmf on the voip call leg(debug voip rtp session named-event), however, unable to see dtmf on the PRI side.

Jonathan Els
Level 5
Level 5

Great doc!  Thank you for your efforts.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: