Hissing is very loud during gaps in speech on VoIP call. This is a comfort noise issue

Document

Jul 22, 2009 7:51 PM
Jun 22nd, 2009

Core Issue

The most likely cause of the hissing during gaps in speech is comfort noise. Test by disabling comfort noise and Voice Activity Detection (VAD). For more information, listen to the Hissing Periods sound recording.

Resolution

To resolve the issue, perform these steps:

  1. Test whether comfort noise is causing the problem:
    • Select an appropriate VoIP dial-peer to test. Issue the  no VAD configuration command under the dial peer.
    • An alternative to entirely disabling VAD is to disable comfort noise on the appropriate voice port. This is done by issuing the no comfort-noise command. Without comfort noise, VAD can cause absolute silence between speech. This can be equally annoying due to the loud hissing. In most cases, it is preferrable to turn VAD off.
    • Set the SilenceSupressionSystemWide and SilenceSupressionWithGateways parameters in all your Cisco CallManagers to false. Select Service > Service Parameters > Select ServerCisco CallManager.

      For more information, refer to Tuning Cisco IP Phone Voice Quality.

    • If the problem persists, check whether VAD is still active on the call by issuing a show call active voice command.
    • If VAD is still active, ensure that you have turned VAD off on the correct dial-peer. In particular, check that the inbound dial peer is being matched with reference to this document for further information on matching inbound dial peers: Voice - Understanding How Inbound and Outbound Dial Peers are Matched on Cisco IOS Platforms.
  2. Next, attempt to tune comfort noise so that the transition from real background noise to comfort noise is masked as much as possible. Issue the voice vad-time global command to control the rate of this transition from rapid to gradual.

   3.  When satisfied that comfort noise is causing the problem, and if tuning the voice vad-time command does not decrease the impact of the problem,        disable VAD on all appropriate dial peers.

For further information, refer to Troubleshooting Hissing and Static.

Overall Rating: 0 (0 ratings)

Actions

Login or Register to take actions

This Document

Posted June 22, 2009 at 4:44 PM
Updated July 22, 2009 at 7:51 PM
Stats:
Comments:0 Overall Rating:0
Views:1249 Contributors:0
Shares:0

Related Content

 
 
 

Documents Leaderboard

Rank Username Points
1
Syed Shahzad Ali
223
2
Gergely Szabo
171
3
Muhammad Amir Raza
92
4
Anthony Holloway
85
5
Jonathan Schulenberg
25