×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to configure the VPN 3000 Concentrator to filter traffic on the client side

Document

Wed, 07/22/2009 - 19:50
Jun 22nd, 2009
User Badges:
  • Gold, 750 points or more

Resolution

To configure the VPN 3000 Concentrator to filter traffic on the client side, create traffic management rules.

To create management rules, perform this procedure:

  1. Configure the management rules with these steps:
         
    1. Select Configuration > Policy Management > Traffic Management > Rules.
       
    2. Click Add.
       
    3. Name the rule, enter the rule details, and click Add.
       
    4. Repeat these steps until all of the rules to be applied to the filter are entered.
       
       
  2. Configure the filter with these steps:
         
    1. Select Configuration > Policy Management > Traffic Management > Filter.
       
    2. Click Add Filter.
       
    3. Name the filter, set the Default Action to Forward, and click Add.
       
    4. Highlight a rule to add to the filter, and click Add.

      Repeat this step until all rules are applied to the filter. The last rule entered must be a "deny all" rule.
       
    5. Click Done.
       
       
  3. Apply the filter to the group with these steps:
         
    1. Select Configuration > User Management > Groups.
       
    2. Highlight the group to which you want to add the filter, and select Modify Group.

    3. Click the General tab, select the filter to be applied to the group from the filter drop-down list, and click Apply.

       
  4. Save the configuration.

For more information, refer to the Traffic Management Rules section of Policy Management.

For more detailed information about how to configure the VPN 3000 Concentrator, refer to the VPN 3000 documentation for the software version in question.

Loading.

Actions

This Document

Related Content