×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Association problems due to the incorrect configuration of the Allow Saved LEAP Username and Password parameter

Document

Wed, 11/18/2009 - 18:22
Jun 22nd, 2009
User Badges:
  • Gold, 750 points or more

Core Issue

If the Allow Saved LEAP Username and Password parameter is not configured correctly, the Cisco Access Point (AP) can encounter association problems. Sometimes the client running LEAP authentication fails to connect when the client enters the username and password for it. This happens because the LEAP Saved Username and Password option forces the client to use this username and password, which is stored within the actual Aironet Desktop Utility (ADU) program.


Resolution

For more information about this issue, refer to the Security Modules section of Installed Components Tab.


For initial configuration of the client adapters, refer to the Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide, OL-4211-03.


Problem Type

Configure / Configuration issues

Device cannot associate

Products

Access point

AIR-CB20A (802.11a)

Security Options

LEAP / RADIUS

Loading.

Actions

This Document

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode