×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

In Cisco Unity, the user cannot open Call Viewer and receives the "Failed to get arbiter component "error message

Document

Wed, 07/22/2009 - 19:46
Jun 22nd, 2009
User Badges:
  • Gold, 750 points or more

Core Issue

This problem occurs if user the user account does not have the proper permissions to launch CallViewer. The account logged may not be associated to any subscriber.


Resolution

To overcome this problem, log in as the UnityAdmin, and make sure to log into the domain, and not the local system.

The user needs to be logged in as an account associated with a Cisco Unity subscriber for Call Viewer to work.

You can also overcome this problem by running Grantunityaccess Utility, which is located at C:\commserver\grantunityaccess.exe. When you run this utility with no options, the instructions are displayed. The normal use of this tool is to provide the domain/alias of the account which is to have access to the SA, and then from which account to copy those rights (for example, - grantunityaccess -u domain\). This adds the account to the tool.

For more information, refer to Administrator Account not Associated with Unity Subscriber

Loading.

Actions

This Document

Related Content