The Cisco Discovery Protocol displays the "%CDP-4-DUPLEX_MISMATCH" error message on Catalyst fixed configuration switches running IOS software.

Document

Jun 22, 2009 5:06 PM
Jun 22nd, 2009

Core issue

The %CDP-4-DUPLEX_MISMATCH messages may be generated repeatedly when Cisco Discovery Protocol (CDP) has discovered a mismatch of duplex configuration between CDP neighbors.

This message occurs when a duplex mismatch is detected between CDP neighbors. It can also occur when switches are separated by a non-Cisco switch or hub. If CDP version 2 reports the link as a half-duplex when a port or interface on a CDP-enabled device has been configured or auto negotiated to full-duplex, the alternate device may not support CDP version 2. This causes the error to occur. It is a cosmetic issue.

CDP is useful for detecting errors as well as port and system statistics on neighboring Cisco devices. CDP is Cisco proprietary and works be sending packets to a well-known MAC address 01-00-0C-CC-CC-CC.

Resolution

To resolve this issue, perform these steps:

  1. To disable CDP version 2, issue the no cdp advertise-v2 command.  

  2. To check the CDP version running on the device, issue the show cdp command.

       

For more information on the CDP-4-DUPLEX_MISMATCH error message, refer to the Error Message Decoder tool.

These Cisco bug IDs also deal with the %CDP-4-DUPLEX_MISMATCH error message:

  • CSCdu13457 - Duplex mismatch on Ethernet between VXR & CAT4003  

  • CSCds50946 - CDP-4-DUPLEX_MISMATCH: Duplex mismatch messages flooding the log  

  • CSCdp30476 - %CDP-4-DUPLEX_MISMATCH messages generated constantly

       

This message indicates a duplex mismatch on one side of the connection:

%CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet5/1 (not half duplex), with TBA05071417(Cat6K-B) 4/1 (half duplex).

By default, Cisco switch ports and interfaces are set to Auto-negotiate. You must match the speed and duplex settings on both sides by setting both sides to Auto-negotiate or by hardcoding.

Note: This error message also occurs in Switches running CatOS system software.

For more information on the causes of speed and duplex mismatches, refer to the Speed/Duplex, Autonegotiation, or NIC Issues section of Troubleshooting Switch Port and Interface Problems.

Average Rating: 5 (1 ratings)

Actions

Login or Register to take actions

This Document

Posted June 22, 2009 at 5:06 PM
Stats:
Comments:0 Avg. Rating:5
Views:14596 Contributors:0
Shares:0
 

Documents Leaderboard