How to address MGCP-3-INTERNAL_ERROR messages while booting


Wed, 11/18/2009 - 18:25
Jun 22nd, 2009
User Badges:
  • Gold, 750 points or more

Core Issue

These messages are caused by the improper use of the boot system command.


To specify an image for the router to use when booting, use the boot system flash:[filename] syntax.

Note: There are no spaces in flash:[filename] to specify the filename of the Cisco IOS  image to be loaded, as shown in this example:

Router(config)# boot system flash:c3640-is-mz.122-12a.bin

For more information on the use of this command, refer to CFR Commands: absolute - clock timezone.



This Document

Related Content