×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to configure security settings on the client adapter and access point

Document

Wed, 11/18/2009 - 18:21
Jun 22nd, 2009
User Badges:
  • Gold, 750 points or more

Core Issue

Need assistance configuring  adapter and access point security settings.


Resolution

In order to use any of the popular security features, both your client adapter and the access point to which it will associate must be set appropriately. For more information on correctly setting your client adapter and the access point refer to Synchronizing Security Features section of Configuring the Client Adapter.


Refer  the following URLs

1. Using EAP authentication in Cisco Aironet 350 and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows

2. Using EAP Authentication in Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide, Release 2.5



Problem Type

Configure / Configuration issues


Products

Access point

BR 350

WLAN adapters (wireless card) / ACU (Aironet Client Utility)

Security Options

MIC

PEAP

WEP key

EAP

LEAP / RADIUS

Loading.

Actions

This Document

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode