cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3776
Views
5
Helpful
0
Comments
TCC_2
Level 10
Level 10

Core issue

This issue happens when installing Catalyst 4000 modules (for example, WS-X4148-RJ45V, WS-X4148-RJ) in slot 10 of the Catalyst 4510R chassis.

The Catalyst 4510R switch supports the Supervisor Engine V and V-10GE. The Supervisor Engine has a nonblocking, full-duplex, switching fabric that provides connections between the Supervisor Engine and the switching modules.

Slot 1 is reserved for the Supervisor Engine only, which provides switching, local and remote management, and switch-status monitoring. Slot 2 is reserved for a redundant Supervisor Engine only. Slots 3 through 9 are available for switching modules.

When using a Supervisor Engine V, slot 10 is a flex-slot for use with the 2-port Gigabit Ethernet switching module (WS-X4302-GB) or the Access Gateway Module (WS-X4604-GWY) only.

Resolution

To resolve this issue, try any of the resolutions steps.

  1. Use a Supervisor Engine V-10GE, which supports any module in slot 10.  
  2. Use Gigabit Ethernet switching module (WS-X4302-GB) or the Access Gateway Module (WS-X4604-GWY) if you are using Supervisor Engine V.
       

For more information, refer to Catalyst 4510R Switch Chassis Features.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: