Rate limit Ethernet traffic on 6509 SUP2/PFC2/MFC2

Document

Oct 8, 2009 12:29 PM
Oct 8th, 2009

The only rate limiting that I can get to work is MQC (service policy) on a physical ethernet routed port but only inbound (traffic outbound from host). I need to rate limit in both directions. No rate limiting method works on a Vlan interface. the commands are supported but have no effect. the rate limit command does nothing as does the traffic-shaping command. Through my testing I have found only the one secenario explained above to actually do any rate limiting. Do I need different cards? is there another method to use I am not familiar with? Is it even possible to rate limit on an ethernet port on a 6509 switch in the outbound direction?

Average Rating: 0 (0 ratings)

Actions

Login or Register to take actions

This Document

Posted October 8, 2009 at 12:29 PM
Stats:
Comments:0 Avg. Rating:0
Views:1721 Contributors:0
Shares:0
Tags: No tags.

Documents Leaderboard

Rank Username Points
1 101
2 20
3 9
4 5
Rank Username Points
10
5