Question: IPSEC VPN - WRVS4400N to Cisco ASA 5510

Document

Oct 14, 2009 10:18 AM
Oct 14th, 2009

Hello all,

I am in dire need of assistance with WRVS4400N Version V2.0.0.7.

I have been attempting for weeks to connect an IPSEC tunnel between a Cisco ASA 5510 Version 8.0(2) and a WRVS4400N . Phase one seems connect okay, where as phase two always give me the errors below. This as far as I have got, I tried disabling keep alive monitor, the device never attempted phase 2.  I have read endless documentation on both devices and tried almost every combination of setting that I am aware of. Any input would be greatly appreciated, the best case scenario answer would be detailed steps on how to setup the IPSEC VPN (linksys) & the site to site VPN (CISCO) as I cannot find any refrence material for this combination .

VPN ERROR

Thank you in advance,

Dan

Average Rating: 0 (0 ratings)

Comments

sibgathullah Sat, 10/17/2009 - 06:44

Dear Dan,

After all your configuration just go to IPSEC rules & exempt ASA side host/network from Address Translation.

Actions

Login or Register to take actions

This Document

Posted October 14, 2009 at 10:18 AM
Stats:
Comments:1 Avg. Rating:0
Views:3226 Contributors:1
Shares:0
Categories: ASA
+

Related Content

Documents Leaderboard

Rank Username Points
1 65
2 56
3 55
4 30
5 24
Rank Username Points
10