Executing "show" Commands in Global Configuration Mode


Nov 4, 2009 6:26 AM
Nov 4th, 2009

This Reader Tip by Tahir Javed explains how to execute "show" commands in Global Configuration mode.

Just type "Do" in start of that privilege mode command and press Enter. It will display as it is output as you can see by executing it in enable privilege mode.

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin-top:0in; mso-para-margin-right:0in; mso-para-margin-bottom:10.0pt; mso-para-margin-left:0in; line-height:115%; mso-pagination:widow-orphan; font-size:11.0pt; font-family:"Calibri","sans-serif"; mso-ascii-font-family:Calibri; mso-ascii-theme-font:minor-latin; mso-fareast-font-family:"Times New Roman"; mso-fareast-theme-font:minor-fareast; mso-hansi-font-family:Calibri; mso-hansi-theme-font:minor-latin;}

For example..

"router(config)#do show ip int brie"

Average Rating: 5 (1 ratings)


Login or Register to take actions

This Document

Posted November 4, 2009 at 6:26 AM
Comments:0 Avg. Rating:5
Views:8435 Contributors:0
Tags: No tags.

Documents Leaderboard