FAQs - WRVS4400N Wireless-N Gigabit Security Router with VPN


Oct 14, 2009 10:11 AM
Aug 17th, 2009
Overall Rating: 0 (0 ratings)
ptsfrank09 Wed, 10/14/2009 - 09:03

I own two of these Routers. One is at my business and the other one is at my home. I bought them with the intention of using VPN Tunnel. Initially I had nothing but problems with them. Over time and hundreds of hours later and through a select few of individuals, the problem was finally resolved. I could finally get the VPN tunnel to work. Of course they had to write a special BETA Firmware just for me, since apparently no one else that purchased these routers had actually setup or tried the VPN tunnel.

I just recently updated my Firmware to Firmware Version: V1.1.13. I've had the Firmware in place for about 1 1/2 to 2 months now as far as I can recall.  Up until last week one of my routers will just work great for about 10-12 hours and then it just stops working. No access to router whatsoever. No Traffic, all lights on but no one home. The ports are getting quite HOT to the touch. I don't understand what is going on. Is my Router going out on me??? What should I do??

chchapma Wed, 10/14/2009 - 10:11

Please contact the Cisco Small Business Support Center at 1 (866) 606-1866 to get help with your WRVS4400N.  Our technical support staff can help diagnose the issue you described.


Login or Register to take actions

This Document

Posted August 17, 2009 at 12:59 PM
Updated August 17, 2009 at 1:01 PM
Comments:2 Overall Rating:0
Views:2075 Contributors:2
Tags: wrvs4400n

Related Content