Initial Configuration of the AIP-SSM Sensor (Video)


Sep 24, 2012 1:26 PM
Jul 25th, 2010

Initial Configuration of the AIP-SSM Sensor:

The initial configuration of the AIP-SSM sensor for the ASA firewall consists of 3 steps:

  1. Configure the basic system parameters of the sensor module by sessioning in to the sensor from the ASA
  2. Send traffic up to the sensor, from the ASA, for inspection
  3. Complete, fine-tune and test the configuration of the sensor from the CLI or IDM GUI.

1. Basic sensor system parameter configuration

2. Sending traffic from the ASA to the Sensor for inspection

3. Complete the sensor configuration using the IDM GUI

Overall Rating: 5 (4 ratings)
paulsenknudsen Wed, 07/28/2010 - 06:04

Thanks for posting that. While the conf is simple, there seems to be preciuse little documentation on this module. I was looking all over to find out how to access the sensor via a SSH session to the ASA. Thank you.


juancarlosmartinez Fri, 12/17/2010 - 11:24


This is a wonderfull video this is the way to do technical stuff.....great job

thanks so much

v-bharath Tue, 02/08/2011 - 05:55

Very Simple and cool doc..

Julio Carvajal Fri, 12/09/2011 - 22:22


Great document!!!

JEFF SPRADLING Mon, 09/24/2012 - 13:26

Can't see the video - right clicking on the area it's supposed to be in shows, "movie not loaded" error, and a link to take me to Adobe's website to see info on ver. 11. 

Is it me, or did someone take down the video's?  I swear Flash is getting as bad as Java....


Login or Register to take actions

This Document

Posted July 25, 2010 at 2:02 AM
Updated August 25, 2010 at 2:01 PM
Comments:5 Overall Rating:5
Views:7029 Contributors:5
Tags: No tags.

Documents Leaderboard

Rank Username Points
Ashley Price