×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

MCU Troubleshooting for CVP Video Solution

Document

Wed, 06/10/2009 - 05:12
Jun 10th, 2009
User Badges:
  • Silver, 250 points or more

Console Login Issue Using Serial Cable

   * The free version of HyperTerminal doesn't work on Windows 2003 server
   * You could use new version of PUTTY software with the console option to console into the MCU

Console Setting

   * Baud rate: 9600
   * Data bits: 8
   * Parity: None
   * Stop bits: 1
   * Flow control: None


 At the ">" prompt, type:   modifyTargetDevice  and then hit enter. 
 This will give you access to menu options without reloading your MCU

Restore Factory  configuration

Select "A" for Advanced and "2" for restore factory configuration. The IP addresses will remain there but all usernames, passwords, gatekeeper IP addresses will be written over.

Loading.

Actions

This Document