Disjoint Layer 2 Uplink

Document

Mon, 04/23/2012 - 21:19
Jan 9th, 2012
User Badges:
  • Cisco Employee,

Introduction

Disjoint layer-2 networks are required if you have two or more Ethernet “clouds” that never connect, but must be accessed by servers or virtual machines located in the same Cisco UCS domain. The configuration for disjoint L2 networks works on a principle of selective exclusion. Traffic for a VLAN that is designated as part of a disjoint network can only travel along an uplink Ethernet port or port channel that is specifically assigned to that VLAN, and is selectively excluded from all other uplink ports and port channels. By default, data traffic in Cisco UCS works on a principle of mutual inclusion. All traffic for all VLANs and upstream networks travels along all uplink ports and port channels.


Disjoint Layer-2 features:

  • Non-symmetric VLANs on uplink
  • Multiple Layer 2 networks upstream
  • Native support in End-Host mode allows simplification of configuration (no need for Switch mode)
  • By default 1.4 behavior is preserved (all VLANs present in all uplinks)
  • Hardware independent feature (supported in 6100 and 6200 FI)
  • Max of 31 disjointed Layer 2 domains supported
  • Overlapping VLAns are not supported
  • Per VLAN broadcast/multicast listener


Requirements

System must be running UCS 2.x version. User should have knowledge of basic UCS configuration.


Related Information

Configuring Upstream Disjoint Layer-2 Networks

Loading.

Actions

This Document

Related Content