The ASA 5510 unit hangs on the initial setup after an upgrade from a Linksys firewall


Jul 22, 2009 7:28 PM
Jun 17th, 2009

Core issue

During a migration from any other firewall to the Adaptive Security Appliance (ASA), the unit hangs and does not respond to any connection. Traffic does not pass through the device after it is replaced.


To resolve this issue, perform these steps:

  1. Check the routing table to confirm that the default route has been added to the configuration.

  2. Configure the service policies according to the applications used in the network. Issue this command:

    policy-map global_policy
    class inspection_default

  3. Reboot the Internet Service Provider (ISP) router, so it can learn the MAC address of the ASA.



Features & Tasks

Initial setup

Overall Rating: 0 (0 ratings)


Login or Register to take actions

This Document

Posted June 17, 2009 at 10:20 PM
Updated July 22, 2009 at 7:28 PM
Comments:0 Overall Rating:0
Views:538 Contributors:0

Related Content