Hola Mirtha,
Si se trata de marcar el mismo número y seleccionar la línea una opción sería el comando de preference bajo el dial-peer de pots. Sin embargo, aquí solo le estarías dando prioridad:
Router(config-dial-peer)# preference value | (Optional) Configures a preference for the POTS dial peer. The valid range is 0 through 10, where the lower the number, the higher the preference. |
Y en caso de que esa línea falle utilizaría otro dial-peer asociado a otra línea. Más información aquí:
http://www.cisco.com/en/US/partner/docs/ios/12_2/voice/configuration/guide/vvfpeers.html?referring_site=bodynav
Si vas a dedicar diferentes números a marcar en cada una de las líneas entonces el destination pattern podrá distinguir entre línease entre los diferentes dial-peers siempre y cuando estos no hagan overlapping. Envío la manera en que funcionan los dial-peers:
Understanding Dial Peers and Call Legs on Cisco IOS Platforms
http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologies_tech_note09186a008010ae1c.shtml
Understanding Inbound and Outbound Dial Peers Matching on IOS Platforms
http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml#topic7
Saludos,
- Pablo