cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2727
Views
0
Helpful
1
Comments
cisco_admin1
Level 3
Level 3

With Luke Primm, Colby Beam and Nicholas Tate 


Read the bioRead the bioRead the bio

Welcome to this Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about converged networks using the Cisco Catalyst 3850 Series Switch with experts Luke Primm, Colby Beam and Nicholas Tate. Our experts will answer all your questions about understanding, configuring, and troubleshooting a converged network using the Cisco Catalyst 3850.

The Cisco Catalyst 3850 is part of a unified access solution based on Cisco’s one policy, one management, one network. One network is the convergence of wired and wireless networks into one physical infrastructure with greater intelligence, performance, features, and operational consistency for simplicity and ease of use.

The Cisco Catalyst 3850 is a converged access switch for both wired and wireless Ethernet. It brings the best of wired and wireless together by supporting wireless tunnel termination and full wireless LAN controller functionality. This technical forum is intended to help answer and aid in the deployment of the Cisco Catalyst 3850 in your network. 

Luke Primm is a member of the TAC LAN switching team at Cisco responsible for the support of all Cisco IOS Software switching platforms. He has more than nine years of experience supporting small to enterprise-sized networks. Luke's technical career started as a high school computer technology teacher responsible for teaching the Cisco Networking Academy curriculum. Upon leaving the classroom, he spent the next eight years in education technology helping design and support K-12 network solutions. Luke graduated from Eastern Washington University with a BS degree in computer technology and recently achieved an MS degree in network architecture from Capella University.

Colby Beam has been a technical leader on the LAN switching team for the past year. Additionally, he spent two years working on the Cisco Nexus 5000 and 2000 platforms. He has more than eight years of experience with networking. Colby also has extensive experience with a wide variety of networks and data centers. He holds a bachelor of science degree in computer science from the University of North Carolina at Asheville. 

Nicholas Tate is a senior customer support engineer in the global technical assistance center supporting wireless technologies, where he works on complex wireless enterprise issues. He has published numerous wireless documents to Cisco.com and the Cisco Support Community. Tate has been with working at Cisco since 2011 and holds a degree in information computer technologies from East Carolina University. 

Remember to use the rating system to let Luke, Colby, and Nicholas know if you have received an adequate response.

They might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Network Infrastructure community and sub-community, LAN, Switching and Routing discussion forum shortly after the event.

This event lasts through December 13, 2013.. Visit this forum often to view responses to your questions and the questions of other community members.

1 Comment
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: