キャンセル
次の結果を表示 
次の代わりに検索 
もしかして: 
cancel
623
閲覧回数
0
いいね!
0
コメント
CscTsWebDocs
Community Member

2012 年 4 月 23 日(初版)

TAC SR Collection
主な問題

IOS XR が動作するルータにおいて、RP の switchover や reload が発生した後、"ipv6 nd suppress-ra" や "ipv6 nd ra-interval" コマンドが適用されていない状態になります。

-----

RP/0/RP1/CPU0:ios#show running-config interface bundle-ether 10

Thu Mar  1 14:07:02.708 CET

interface Bundle-Ether10

ipv6 nd ra-interval 4 3

ipv6 nd suppress-ra

ipv6 address fd00:f4a8:0:fe0a::1/126

-----

この設定がされている場合でも、RP の switchover 後は、同コマンドが有効になっていません。

以下は RP switchover 後の出力です。

-----

RP/0/RP1/CPU0:ios#show ipv6 interface bundle-ether 10

Thu Mar  1 14:05:57.572 CET

Bundle-Ether10 is Up, ipv6 protocol is Up, Vrfid is default (0x60000000)

   IPv6 is enabled, link-local address is fe80::21a:a1ff:fe68:4900

   Global unicast address(es):

     fd00:f4a8:0:fe0a::1, subnet is fd00:f4a8:0:fe0a::/126

   Joined group address(es): ff02::1:ff00:1 ff02::1:ff68:4900 ff02::2

       ff02::1

   MTU is 1514 (1500 is available to IPv6)

   ICMP redirects are disabled

   ICMP unreachables are enabled

   ND DAD is enabled, number of DAD attempts 1

   ND reachable time is 0 milliseconds

   ND advertised retransmit interval is 0 milliseconds

   ND router advertisements are sent every 160 to 240 seconds     <<<<<

   ND router advertisements live for 1800 seconds                 <<<<<

   Hosts use stateless autoconfig for addresses.

   Outgoing access list is nd_ra_suppress

   Inbound  access list is not set

   Table Id is 0xe0800000

-----

この問題は、CSCty35605 において報告されています。

CSCty35605

ipv6 nd ra config not applied after RP FO or upgrade         

解決策

改修版ソフトウェア :
CSCty35605 の修正が適用されたソフトウェアの使用

不具合の暫定回避策 :
コマンドの削除、再適用にて復旧します。        

備考

Getting Started

検索バーにキーワード、フレーズ、または質問を入力し、お探しのものを見つけましょう

シスコ コミュニティをいち早く使いこなしていただけるよう役立つリンクをまとめました。みなさんのジャーニーがより良いものとなるようお手伝いします