sh run
Building configuration...

Current configuration : 2160 bytes
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname HubABA
!
boot-start-marker
boot-end-marker
!
enable password <deleted>
!
no aaa new-model
!
resource policy
!
memory-size iomem 15
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
ip subnet-zero
ip cef
!
no ip dhcp use vrf connected
no ip dhcp conflict logging
ip dhcp excluded-address 192.168.1.1 192.168.1.10
!
ip dhcp pool LAN_LOCAL
   network 192.168.1.0 255.255.255.0
   dns-server 200.44.32.12 
   default-router 192.168.1.1 
!
!
no ip ips deny-action ips-interface
!
no ftp-server write-enable
!
voice-card 0
!
crypto isakmp policy 1
 encr 3des
 authentication pre-share
 group 2
crypto isakmp key <deleted> address 0.0.0.0 0.0.0.0
no crypto isakmp ccm
!
crypto ipsec transform-set trans2 esp-des esp-md5-hmac 
 mode transport
!
crypto ipsec profile SDM_Profile1
 set transform-set trans2 
!
interface Tunnel0
 bandwidth 1000
 ip address 172.25.0.1 255.255.255.0
 no ip redirects
 ip mtu 1400
 ip nhrp authentication <deleted>
 ip nhrp map multicast dynamic
 ip nhrp network-id 99
 ip nhrp holdtime 300
 ip tcp adjust-mss 1360
 delay 1000
 tunnel source FastEthernet0/0
 tunnel mode gre multipoint
 tunnel key 100000
 tunnel protection ipsec profile SDM_Profile1
!
interface FastEthernet0/0
 ip address dhcp
 ip nat outside
 ip virtual-reassembly
 duplex auto
 speed auto
!
interface FastEthernet0/1
 description LAN-LOCAL
 ip address 192.168.1.1 255.255.255.0
 ip nat inside
 ip virtual-reassembly
 duplex auto
 speed auto
!
interface Async0/1/0
 no ip address
!
router eigrp 1
 network 172.25.0.0 0.0.0.255
 network 190.0.0.0
 network 192.168.1.0
 no auto-summary
!
ip classless
ip route 0.0.0.0 0.0.0.0 FastEthernet0/0
!
ip http server
no ip http secure-server
ip nat inside source list 101 interface FastEthernet0/0 overload
!
access-list 101 permit ip any any
!
control-plane
!
line con 0
 password <deleted>
 login
line aux 0
line 0/1/0
 stopbits 1
 speed 115200
 flowcontrol hardware
line vty 0 4
 password <deleted>
 login
!
end

HubABA#