sh mpls l2transport vc Local intf Local circuit Dest address VC ID Status ------------- -------------------- --------------- ---------- ---------- Vl23 Eth VLAN 23 2.2.2.2 100 UP r1#sh mpls l2transport vc  summ Destination address: 2.2.2.2, total number of vc: 1 0 unknown, 1 up, 0 down, 0 admin down 1 active vc on MPLS interface Vl300 r1#sh tag for Local Outgoing Prefix Bytes tag Outgoing Next Hop tag tag or VC or Tunnel Id switched interface 16 Pop tag 2.2.2.2/32 0 Vl300 10.10.10.2 17 Pop tag 99.99.99.0/24 0 Vl300 10.10.10.2 18 Untagged l2ckt(100) 0 Vl23 point2point r1#sh run int vlan23 Building configuration... Current configuration : 94 bytes ! interface Vlan23 no ip address tag-switching ip mpls l2transport route 2.2.2.2 100 end r1#sh run int lo0 Building configuration... Current configuration : 61 bytes ! interface Loopback0 ip address 1.1.1.1 255.255.255.0 end r1#sh run int gi1/47 Building configuration... Current configuration : 115 bytes ! interface GigabitEthernet1/47 switchport switchport access vlan 23 switchport mode access no ip address end r1#s  h tad   g r1#sh mpll\ s  s ldp dis Local LDP Identifier: 1.1.1.1:0 Discovery Sources: Interfaces: Vlan12 (ldp): xmit Vlan23 (ldp): xmit Vlan300 (ldp): xmit/recv LDP Id: 2.2.2.2:0 Targeted Hellos: 1.1.1.1 -> 2.2.2.2 (ldp): active/passive, xmit/recv LDP Id: 2.2.2.2:0 r1#sh mpls ldp dis   neigh Peer LDP Ident: 2.2.2.2:0; Local LDP Ident 1.1.1.1:0 TCP connection: 2.2.2.2.11020 - 1.1.1.1.646 State: Oper; Msgs sent/rcvd: 525/523; Downstream Up time: 07:18:25 LDP discovery sources: Vlan300, Src IP addr: 10.10.10.2 Targeted Hello 1.1.1.1 -> 2.2.2.2, active, passive Addresses bound to peer LDP Ident: 2.2.2.2 10.10.10.2 99.99.99.2 r1#telnet 2.2.2.2 Trying 2.2.2.2 ... Open User Access Verification Password: r2#sh tag for Local Outgoing Prefix Bytes tag Outgoing Next Hop tag tag or VC or Tunnel Id switched interface 16 Untagged l2ckt(100) 0 Vl23 point2point 17 Untagged 1.1.1.1/32 0 Vl300 10.10.10.1 18 Pop tag 12.12.12.0/24 0 Vl300 10.10.10.1 r2#sh run int lo0 Building configuration... Current configuration : 83 bytes ! interface Loopback0 ip address 2.2.2.2 255.255.255.255 ip pim sparse-mode end r2#sh run int l gi1/45 Building configuration... Current configuration : 115 bytes ! interface GigabitEthernet1/45 switchport switchport access vlan 23 switchport mode access no ip address end r2#sh run int vlan 23 Building configuration... Current configuration : 94 bytes ! interface Vlan23 no ip address tag-switching ip mpls l2transport route 1.1.1.1 100 end r2#sh mpl r2#sh mpls l2t r2#sh mpls l2transport vc Local intf Local circuit Dest address VC ID Status ------------- -------------------- --------------- ---------- ---------- Vl23 Eth VLAN 23 1.1.1.1 100 DOWN r2#sh mpls l2transport vc  summ Destination address: 1.1.1.1, total number of vc: 1 0 unknown, 0 up, 1 down, 0 admin down r2#sh mpls ldp neigh Peer LDP Ident: 1.1.1.1:0; Local LDP Ident 2.2.2.2:0 TCP connection: 1.1.1.1.646 - 2.2.2.2.11020 State: Oper; Msgs sent/rcvd: 524/526; Downstream Up time: 07:19:16 LDP discovery sources: Vlan300, Src IP addr: 10.10.10.1 Targeted Hello 2.2.2.2 -> 1.1.1.1, active, passive Addresses bound to peer LDP Ident: 1.1.1.1 20.20.20.1 12.12.12.1 10.10.10.1 r2#sh mpls ldp neigh     dis Local LDP Identifier: 2.2.2.2:0 Discovery Sources: Interfaces: Vlan999 (ldp): xmit Vlan300 (ldp): xmit/recv LDP Id: 1.1.1.1:0 Vlan23 (ldp): xmit Targeted Hellos: 2.2.2.2 -> 1.1.1.1 (ldp): active/passive, xmit/recv LDP Id: 1.1.1.1:0 r2#