T term mo  el  leng 0 IPTPOCR1# IPTPOCR1#sh run Building configuration... Current configuration : 2076 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname IPTPOCR1 ! boot-start-marker boot-end-marker ! card type e1 0 1 logging message-counter syslog enable secret 5 $1$nmFx$9.FFwt2TPYNKL9FVk4Zo91 ! no aaa new-model network-clock-participate wic 1 ! dot11 syslog ip source-route ! ! ip cef ! ! no ipv6 cef ! multilink bundle-name authenticated ! ! ! ! isdn switch-type primary-qsig ! ! voice call send-alert ! voice service pots ! voice service voip allow-connections h323 to sip allow-connections sip to h323 signaling forward unconditional h323 sip ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! voice-card 0 codec complexity medium ! ! ! ! ! archive log config hidekeys ! ! ! ! ! controller E1 0/1/0 framing NO-CRC4 pri-group timeslots 1-8,16 ! ! ! ! ! interface GigabitEthernet0/0 ip address 10.158.67.89 255.255.255.0 duplex full speed 100 h323-gateway voip interface h323-gateway voip bind srcaddr 10.158.67.89 ! interface GigabitEthernet0/1 no ip address shutdown duplex auto speed auto ! interface Serial0/1/0:15 no ip address encapsulation hdlc isdn switch-type primary-qsig isdn timer T310 50000 isdn overlap-receiving isdn protocol-emulate network isdn incoming-voice voice no cdp enable ! ip default-gateway 10.158.67.254 ip forward-protocol nd ip route 0.0.0.0 0.0.0.0 10.158.67.254 no ip http server no ip http secure-server ! ! ! ! ! ! ! ! ! ! control-plane ! ! ! voice-port 0/1/0:15 ! ccm-manager fax protocol cisco ! mgcp fax t38 ecm ! ! ! dial-peer voice 1 pots destination-pattern .T direct-inward-dial port 0/1/0:15 forward-digits all ! dial-peer voice 2 voip destination-pattern 1... session target ipv4:10.158.67.90 ! dial-peer voice 3 pots destination-pattern 701 direct-inward-dial port 0/1/0:15 forward-digits all ! dial-peer voice 4 pots destination-pattern 801 direct-inward-dial port 0/1/0:15 forward-digits all ! ! ! ! line con 0 password cisco login line aux 0 line vty 0 4 password cisco login ! scheduler allocate 20000 1000 end IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1#sho isdn stat Global ISDN Switchtype = primary-qsig ISDN Serial0/1/0:15 interface ******* Network side configuration ******* dsl 0, interface ISDN Switchtype = primary-qsig **** Master side configuration **** Layer 1 Status: ACTIVE Layer 2 Status: TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED Layer 3 Status: 0 Active Layer 3 Call(s) Active dsl 0 CCBs = 0 The Free Channel Mask: 0x800000FF Number of L2 Discards = 0, L2 Session ID = 0 Total Allocated ISDN CCBs = 0 IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1#sho ip inter brie Interface IP-Address OK? Method Status Protocol GigabitEthernet0/0 10.158.67.89 YES NVRAM up up GigabitEthernet0/1 unassigned YES NVRAM administratively down down Serial0/1/0:0 unassigned YES unset down down Serial0/1/0:1 unassigned YES unset down down Serial0/1/0:2 unassigned YES unset down down Serial0/1/0:3 unassigned YES unset down down Serial0/1/0:4 unassigned YES unset down down Serial0/1/0:5 unassigned YES unset down down Serial0/1/0:6 unassigned YES unset down down Serial0/1/0:7 unassigned YES unset down down Serial0/1/0:15 unassigned YES NVRAM up up SSLVPN-VIF0 unassigned NO unset up up IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1#sho controller e1 E1 0/1/0 is up. Applique type is Channelized E1 - balanced Cablelength is Unknown No alarms detected. alarm-trigger is not set Version info Firmware: 20071011, FPGA: 13, spm_count = 0 Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line. Data in current interval (98 seconds elapsed): 0 Line Code Violations, 0 Path Code Violations 3 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 3 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs Total Data (last 3 15 minute intervals): 1 Line Code Violations, 0 Path Code Violations, 89 Slip Secs, 0 Fr Loss Secs, 1 Line Err Secs, 0 Degraded Mins, 89 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1#sh inter seri 0/1/0:15 Serial0/1/0:15 is up, line protocol is up (spoofing) Hardware is DSX1 MTU 1500 bytes, BW 64 Kbit/sec, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation HDLC, loopback not set Last input 00:00:03, output never, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: weighted fair Output queue: 0/1000/64/0 (size/max total/threshold/drops) Conversations 0/1/256 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) Available Bandwidth 48 kilobits/sec 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 407 packets input, 1627 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 407 packets output, 1761 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 unknown protocol drops 0 output buffer failures, 0 output buffers swapped out 1 carrier transitions Timeslot(s) Used:16, SCC: 0, Transmitter delay is 0 flags IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1#s sh isdn serve  PRI Channel Statistics: ISDN Se0/1/0:15, Channel [1-31] Configured Isdn Interface (dsl) 0 Channel State (0=Idle 1=Proposed 2=Busy 3=Reserved 4=Restart 5=Maint_Pend) Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 State : 0 0 0 0 0 0 0 0 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 Service State (0=Inservice 1=Maint 2=Outofservice 8=MaintPend 9=OOSPend) Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 State : 0 0 0 0 0 0 0 0 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1# IPTPOCR1#t