C ***************************************************************************** * ************WARNING************** * * THIS SYSTEM IS PROPERTY OF ORGANIZATION AND ACCESS TO THIS SYSTEM IS * *STRICTLY RESTRICTED TO AUTHORIZED PERSONS ONLY.EVERY ACTIVITY IS MONITORED * * CONTINEOUSLY ON THIS SYSTEM.UNAUTHORIZED ACCESS IS NOT ALLOWED ON THIS * * SYSTEM AND LEAGAL ACTION CAN BE TAKEN FOR UNAUTHORISED USERS * ***************************************************************************** User Access Verification Username: % Username: timeout expired! % Authentication failed. Username: Username: Username: Username: Username: Username: Username: Username: ********************************************************** * * * Welcome to Rom Monitor for WS-X4013+10GE System. * * Copyright (c) 2003-2006 by Cisco Systems, Inc. * * All rights reserved. * * * ********************************************************** Rom Monitor Program Version 12.2(31r)SGA Supervisor: WS-X4013+10GE Chassis: WS-C4507R-E Hardware Revisions - Board: 9.4 CPLD Tie: 32 FPGA Pod: 14 MAC Address : 00-15-62-e6-eb-4a Ip Address : Not set. Netmask : Not set. Gateway : Not set. TftpServer : Not set. ***** The system will autoboot in 5 seconds ***** Type control-C to prevent autobooting. Autoboot cancelled......... please wait!!! Autoboot cancelled......... please wait!!! rommon 1 > [interrupt] rommon 1 > [interrupt] rommon 1 > [interrupt] rommon 1 > [interrupt] rommon 1 > [interrupt] rommon 1 >confred g Configuration Summary : => load rom after netboot fails => console baud: 9600 => autoboot from: the first file from internal flash device do you wish to change the configuration? y/n [n]: y enable "diagnostic mode"? y/n [n]: n enable "use net in IP bcast address"? y/n [n]: n disable "load rom after netboot fails"? y/n [n]: n enable "use all zero broadcast"? y/n [n]: n enable "break/abort has effect"? y/n [n]: n enable "ignore system config info"? y/n [n]: y change console baud rate? y/n [n]: n change the boot characteristics? y/n [n]: n Configuration Summary : => load rom after netboot fails => ignore system config info => console baud: 9600 => autoboot from: the first file from internal flash device do you wish to save this configuration? y/n [n]: y You must reset or power cycle for new configuration to take effect rommon 2 >reset Resetting ....... rommon 3 > ********************************************************** * * * Welcome to Rom Monitor for WS-X4013+10GE System. * * Copyright (c) 2003-2006 by Cisco Systems, Inc. * * All rights reserved. * * * ********************************************************** Rom Monitor Program Version 12.2(31r)SGA Supervisor: WS-X4013+10GE Chassis: WS-C4507R-E Hardware Revisions - Board: 9.4 CPLD Tie: 32 FPGA Pod: 14 MAC Address : 00-15-62-e6-eb-4a Ip Address : Not set. Netmask : Not set. Gateway : Not set. TftpServer : Not set. ***** The system will autoboot in 5 seconds ***** Type control-C to prevent autobooting. . . . . . ******** The system will autoboot now ******** config-register = 0x2141 Autobooting using the first file from bootflash..... Rommon reg: 0x0E004180 ############ k2diags version 5.2_b prod: WS-X4013+10GE part: 73-10178-07 serial: JAE12045SWR Power-on-self-test for Module 3: WS-X4013+10GE Port/Test Status: (. = Pass, F = Fail, U = Untested) Reset Reason: PowerUp Software/User Cpu Subsystem Tests ... seeprom: . temperature_sensor: . eobc: . Port Traffic: L3 Serdes Loopback ... 0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . 12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 24: . 25: . 26: . 27: . 28: . 29: . 48: . 49: . 50: . 51: . Local 10GE Port 62: U Local 10GE Port 63: U Port Traffic: L2 Serdes Loopback ... 0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . 12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 24: . 25: . 26: . 27: . 28: . 29: . 48: . 49: . 50: . 51: . Port Traffic: L2 Asic Loopback ... 0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . 12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 24: . 25: . 26: . 27: . 28: . 29: . 48: . 49: . 50: . 51: . Switch Subsystem Memory ... 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . 12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 24: . 25: . 26: . 27: . 28: . 29: . 30: . 31: . 32: . 33: . 34: . 35: . 36: . 37: . 38: . 39: . 40: . 41: . 42: . 43: . 44: . 45: . 46: . 47: . 48: . 49: . 50: . 51: . Module 3 Passed Exiting to ios... Rommon reg: 0x0E000180 ##################################### Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASE-M), Version 12.2(40)SG, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2007 by Cisco Systems, Inc. Compiled Wed 07-Nov-07 19:03 by prod_rel_team Image text-base: 0x10000000, data-base: 0x1169F318 *********************************** * STANDBY SUPERVISOR * * REDUNDANCY mode is SSO * * Continue bootup * *********************************** cisco WS-C4507R-E (MPC8540) processor (revision 4) with 262144K bytes of memory. Processor board ID FOX114217CS MPC8540 CPU at 667Mhz, Supervisor II-PLUS-10GE Last reset from PowerUp 96 FastEthernet interfaces 32 Gigabit Ethernet interfaces 4 Ten Gigabit Ethernet interfaces 511K bytes of non-volatile configuration memory.  Press RETURN to get started! C ***************************************************************************** * ************WARNING************** * * THIS SYSTEM IS PROPERTY OF ORGANIZATION AND ACCESS TO THIS SYSTEM IS * *STRICTLY RESTRICTED TO AUTHORIZED PERSONS ONLY.EVERY ACTIVITY IS MONITORED * * CONTINEOUSLY ON THIS SYSTEM.UNAUTHORIZED ACCESS IS NOT ALLOWED ON THIS * * SYSTEM AND LEAGAL ACTION CAN BE TAKEN FOR UNAUTHORISED USERS * ***************************************************************************** User Access Verification Username: Username: % Username: timeout expired! % Authentication failed. Username: % Username: timeout expired! % Authentication failed. Username: % Username: timeout expired! % Authentication failed.