there is ospf running in my network and when I check routing in distribution switch I can see multiple paths, but when I trace route from l2 access switch I cant see mutiple path , but when I try trace route from l3 distribution switch I can see mult...
Hi,Switch#show interface status.Gix/x err-disabled 500 full auto 10/100/1000BasSwitch#sh interfaces gigabitEthernet x/xGigabitEthernet x/x is down, line protocol is down (err-disabled)I tried to re –enabled those ports , but no ...
Ok , I thought it was not resolved. thanx.One Question : you had told earlier , you had recieved authentication mismatch , if it was line problem why did u say authentication mismatch ?Regards,M.I.
Hi,I assume your tunnel interface is up in both the end, and both the IP is reachable.Then, remove tunnel interface network from router ospf xx , and give the ospf command in interface level ( like under interface tunnxx , ip ospf area xx ) ,then s...
Ok , As it is a tunnel interface , no need to configure mtu , point-point network type ( by default it is point-point interface only) , and ip ospf mtu-ignore.Please remove these command (on both side) , and see the result. if it's not working again...
