Is this commands are supported to configure SNR level in cisco 1801 routersADSLISP# configure terminalADSLISP(config)# dsl-profile MYISPADSLISP(cfg-dsl-profile)# cap margin downstream 0-12upstream 0-12 (Set the SNR downstream and upstream margins to...
We are using dynamic ip in our site , with the help of dyndns we can use RDP , FTP, etc , while doing the port forwarding to UC 500 ,we cannot connect using cisco vpn dialer , but applications like telnet ,ssh will work properly , we created dmz...
Hi, Once I upgraded uc 500 to never version SBCS UC 520-8.0.0 , our 7911 phones work normally but speaker phone function is not functioning .When we dial out using the speaker, we are not hearing the sound of the party we called .Is there any thing...
Our DID numbers starts from 00 to 99.User using DID 51 wants 00 and 51 as outbound caller ID (phones are 7945G ) ,DID 00 is used as our reception , Is it possible to configure this.Waiting for your Valuable inputs.
We are Having E1 line connected to UC 500.Whenever a user tries to call someone and the called party sends a BUSY tone , the disconnection Time takes 5 to 10 sec, i have modified voice port to disconnect within 0 secs but still the issue is not reso...
Paolo My question the above commands are possible to execute in 1801 i need a specific answer by mistake i clicked correct in your last reply i like to keep this topic open
Thanks Jhon The changes applied successfully. I can get the ICMP REPLY from Reply from 165.1.1.3: bytes=32 time=331ms TTL=235However, still I cannot ping the internal interface 192.168.1.1, then acess cue http://10.1.10.1 , can you help in resolvin...
HI John Platt Now the vpn client is terminating using the DYNDNS host name , but I cannot access my internal network , what is next for accessing my internal network?My Internal address starts with 192.168.1.0/24.Thanks
