sh run
Building configuration...

Current configuration : 4576 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname kerner
!
boot-start-marker
boot-end-marker
!
card type t1 0 0
logging buffered 51200 warnings
enable secret x xxxxxxxxxxxxxxxx
!
no aaa new-model
!
resource policy
!
no network-clock-participate wic 0 
ip subnet-zero
 --More--         !
!
ip cef
!
!
ip domain name yourdomain.com
!
!
!
crypto pki trustpoint TP-self-signed-111111111
 enrollment selfsigned
 subject-name cn=IOS-Self-Signed-Certificate-11111111
 revocation-check none
 rsakeypair TP-self-signed-11111111111
!
!
crypto pki certificate chain TP-self-signed-111111111
 certificate self-signed 01
  .........
  quit
username cisco privilege 15 secret xxxxxxxxxxxxxxxx
!
!
controller T1 0/0/0
 framing esf
 linecode b8zs
 channel-group 0 timeslots 1-24
!
 --More--         controller T1 0/0/1
 framing esf
 linecode b8zs
 channel-group 0 timeslots 1-24
! 
!
!
!
interface Multilink1
 description CIRCUIT ID xxxxxxxxx; tel for outage xxxxxxxxxx
 bandwidth 3072
 ip address xxxxxxxx 255.255.255.252
 ppp multilink
 ppp multilink group 1
!
interface GigabitEthernet0/0
 description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$
 ip address xxxxxxx 255.255.255.224
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 no ip mroute-cache
 duplex auto
 --More--          speed 1000
 no cdp enable
!
interface GigabitEthernet0/1
 no ip address
 shutdown
 duplex auto
 speed auto
!
interface Serial0/0/0:0
 bandwidth 1536
 no ip address
 encapsulation ppp
 ppp multilink
 ppp multilink group 1
!
interface Serial0/0/1:0
 bandwidth 1536
 no ip address
 encapsulation ppp
 ppp multilink
 ppp multilink group 1
!
 --More--         ip classless
!
ip http server
ip http access-class 23
ip http authentication local
ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
access-list 23 permit 10.10.10.0 0.0.0.7
!
!
control-plane
!
!
banner login ^C

banner motd ^C
Only uthorized users are allowed access to this hardware.
^C
!
line con 0
 exec-timeout 0 0
 password x xxxxxxxx
 logging synchronous
 login
line aux 0
 --More--          password xxxxxxxxxxxxx
 login
line vty 0 4
 access-class 23 in
 privilege level 15
 password xxxxxxxxxxxxxxxxx
 login
 transport input telnet ssh
line vty 5 15
 access-class 23 in
 privilege level 15
 login local
 transport input telnet ssh
!
scheduler allocate 20000 1000
!
end

kerner#sh int multi
kerner#sh int multilink 1
Multilink1 is down, line protocol is down 
  Hardware is multilink group interface
  Description: CIRCUIT ID xxxxxxxx; tel for outage xxxxxxxxx
  Internet address is xxxxxxxxxxx
  MTU 1500 bytes, BW 3072 Kbit, DLY 100000 usec, 
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, LCP Closed, multilink Closed, loopback not set
  Keepalive set (10 sec)
  DTR is pulsed for 2 seconds on reset
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 1d01h
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
kerner#