sh line Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int 0 CTY - - - - - 0 0 0/0 - * 1 AUX 57600/57600 - inout - - - 0 0 0/0 - * 2 VTY - - - - 23 4 0 0/0 - 3 VTY - - - - 23 0 0 0/0 - 4 VTY - - - - 23 0 0 0/0 - 5 VTY - - - - 23 0 0 0/0 - 6 VTY - - - - 23 0 0 0/0 - h hobart# sh line aux 0 Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 1 AUX 115200/115200- inout - - - 0 0 0/0 - Line 1, Location: "", Type: "" Length: 24 lines, Width: 80 columns Baud rate (TX/RX) is 115200/115200, no parity, 2 stopbits, 8 databits Status: Ready, Active, No Exit Banner, Modem Configuring, Modem Speed Locked, Autoconfig Running Capabilities: EXEC Suppressed, Hardware Flowcontrol In, Hardware Flowcontrol Out, Modem Callout, Modem RI is CD, Modem Autoconfigure Modem state: Ready Modem hardware state: noCTS noDSR DTR RTS Special Chars: Escape Hold Stop Start Disconnect Activation ^^x none - - none Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch 00:10:00 never none not set Idle Session Disconnect Warning never Login-sequence User Response 00:00:30 Autoselect Initial Wait not set Modem type is mytest. Session limit is not set. Time since activation: never Editing is enabled. History is enabled, history size is 20. DNS resolution in show commands is enabled Full user help is disabled Allowed input transports are telnet ssh. Allowed output transports are telnet ssh. Preferred transport is telnet. No output characters are padded No special data dispatching characters hobart#telnet 192.168.17.1 2001 Trying 192.168.17.1, 2001 ... % Connection refused by remote host hobart#