Cisco-123-AS-002# Cisco-123-AS-002#sh ver Cisco IOS Software, C3750 Software (C3750-IPBASE-M), Version 12.2(25)SEE2, RELEA SE SOFTWARE (fc1) Copyright (c) 1986-2006 by Cisco Systems, Inc. Compiled Fri 28-Jul-06 08:46 by yenanh Image text-base: 0x00003000, data-base: 0x00EE3E54 ROM: Bootstrap program is C3750 boot loader BOOTLDR: C3750 Boot Loader (C3750-HBOOT-M) Version 12.2(25r)SEE4, RELEASE SOFTWA RE (fc1) Cisco-123-AS-002 uptime is 3 days 1 hour 33 minutes System returned to ROM by power-on System image file is "flash:c3750-ipbase-mz.122-25.SEE2/c3750-ipbase-mz.122-25.S EE2.bin" cisco WS-C3750G-48PS (PowerPC405) processor (revision F0) with 118784K/12280K by tes of memory. Processor board ID FOC1107Y3ER Last reset from power-on 1 Virtual Ethernet interface 52 Gigabit Ethernet interfaces The password-recovery mechanism is enabled. 512K bytes of flash-simulated non-volatile configuration memory. Base ethernet MAC Address : 00:1B:2A:EE:c4:80 Motherboard assembly number : 73-10216-08 Power supply part number : 341-0108-03 Motherboard serial number : FOC1107EY3R Power supply serial number : DCA11040341 Model revision number : F0 Motherboard revision number : C0 Model number : WS-C3750G-48PS-S System serial number : FOC11070019 Top Assembly Part Number : 800-26853-01 Top Assembly Revision Number : B0 Version ID : V05 CLEI Code Number : CNMWN00ARC Hardware Board Revision Number : 0x09 Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 3 52 WS-C3750G-48PS 12.2(25)SEE2 C3750-IPBASE-M Configuration register is 0xF Cisco-123-AS-002#sh switch Current Switch# Role Mac Address Priority State -------------------------------------------------------- *3 Master 001b.2aee.c480 1 Ready Cisco-123-AS-002# Cisco-123-AS-002# Cisco-123-AS-002#sh monitor session all No SPAN configuration is present in the system. Cisco-123-AS-002#sh run interface gig3/0/21 Building configuration... Current configuration : 55 bytes ! interface GigabitEthernet3/0/21 no ip-address end Cisco-123-AS-002#sh int gig Cisco-123-AS-002#sh int gigabitEthernet 3/0/21 GigabitEthernet3/0/29 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is 001b.2aee.c495 (bia 001b.2aee.c495) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX input flow-control is off, output flow-control is unsupported ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts (0 multicast) 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input 0 input packets with dribble condition detected 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 1 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out Cisco-123-AS-002#show etherchannel summary Flags: D - down P - in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggregator u - unsuitable for bundling w - waiting to be aggregated d - default port Number of channel-groups in use: 0 Number of aggregators: 0 Group Port-channel Protocol Ports ------+-------------+-----------+-----------------------------------------------