Compiled Mon 22-Jul-02 18:57 by antonino WS-C2950C-24 starting... Base ethernet MAC Address: 00:07:4f:12:1d:c0 Xmodem file system is available. The system has been interrupted prior to initializing the flash filesystem. The following commands will initialize the flash filesystem, and finish loading the operating system software: flash_init load_helper boot switch: flash_init Initializing Flash... flashfs[0]: 358 files, 4 directories flashfs[0]: 0 orphaned files, 0 orphaned directories flashfs[0]: Total bytes: 7741440 flashfs[0]: Bytes used: 4665856 flashfs[0]: Bytes available: 3075584 flashfs[0]: flashfs fsck took 7 seconds. ...done initializing flash. Boot Sector Filesystem (bs:) installed, fsid: 3 Parameter Block Filesystem (pb:) installed, fsid: 4 switch: load_helper switch: boot Loading "flash:c2950-i6q4l2-mz.121-22.EA4.bin"...########################################################################################################################################################################################################### File "flash:c2950-i6q4l2-mz.121-22.EA4.bin" uncompressed and installed, entry point: 0x80010000 executing... Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA4, RELEASE SOFTWARE (fc1) Copyright (c) 1986-2005 by cisco Systems, Inc. Compiled Wed 23-Mar-05 15:33 by yenanh Image text-base: 0x80010000, data-base: 0x80562000 Initializing flashfs... flashfs[1]: 358 files, 4 directories flashfs[1]: 0 orphaned files, 0 orphaned directories flashfs[1]: Total bytes: 7741440 flashfs[1]: Bytes used: 4665856 flashfs[1]: Bytes available: 3075584 flashfs[1]: flashfs fsck took 7 seconds. flashfs[1]: Initialization complete. Done initializing flashfs. POST: System Board Test : Passed POST: Ethernet Controller Test : Passed ASIC Initialization Passed POST: FRONT-END LOOPBACK TEST : Passed cisco WS-C2950C-24 (RC32300) processor (revision B0) with 21039K bytes of memory. Processor board ID FAB0538W03U Last reset from system-reset Running Enhanced Image 26 FastEthernet/IEEE 802.3 interface(s) 32K bytes of flash-simulated non-volatile configuration memory. Base ethernet MAC Address: 00:07:4F:12:1D:C0 Motherboard assembly number: 73-5750-08 Power supply part number: 34-0971-01 Motherboard serial number: FAB0537B3H5 Power supply serial number: DAB05320V0S Model revision number: B0 Model number: WS-C2950C-24 System serial number: FAB0538W03U --- System Configuration Dialog --- Would you like to enter the initial configuration dialog? [yes/no]:  Press RETURN to get started! 00:00:14: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan 00:00:18: %SYS-5-RESTART: System restarted -- Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA4, RELEASE SOFTWARE (fc1) Copyright (c) 1986-2005 by cisco Systems, Inc. Compiled Wed 23-Mar-05 15:33 by yenanh 00:00:18: %SNMP-5-COLDSTART: SNMP agent on host Switch is undergoing a cold start 00:00:18: %EXPRESS_SETUP-6-MODE_ENTERED: 00:00:21: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch> Switch>en Switch#config t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)# /////// In this condition it started for 5 min and than started as below ) exiting from express setup mode...IP connections may be lost... 00:03:37: %EXPRESS_SETUP-6-MODE_EXITED: 00:03:45: %EXPRESS_SETUP-6-CONFIG_IS_RESET: The configuration is reset and the system will now reboot 00:03:46: %SYS-5-RELOAD: Reload requested C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1) Compiled Mon 22-Jul-02 18:57 by antonino WS-C2950C-24 starting... Base ethernet MAC Address: 00:07:4f:12:1d:c0 Xmodem file system is available. The system has been interrupted prior to initializing the flash filesystem. The following commands will initialize the flash filesystem, and finish loading the operating system software: flash_init load_helper boot switch: