r00583#sh debugging Dial on demand: Dial on demand events debugging is on PPP: PPP authentication debugging is on PPP protocol errors debugging is on PPP protocol negotiation debugging is on The following ISDN debugs are enabled on all DSLs: debug isdn error is ON. debug isdn q931 is ON. *Mar 21 04:22:50.510: ISDN BR0/0 Q931: RX <- SETUP pd = 8 callref = 0x56 Sending Complete Bearer Capability i = 0x8890 Standard = CCITT Transer Capability = Unrestricted Digital Transfer Mode = Circuit Transfer Rate = 64 kbit/s Channel ID i = 0x8A Called Party Number i = 0xC1, '93506018' Plan:ISDN, Type:Subscriber(local) *Mar 21 04:22:50.514: ISDN BR0/0 **ERROR**: host_incoming_call: Incoming call id 0x95 rejected, exceeded allowed number of calls Current 2, Maximum 2 *Mar 21 04:22:50.522: ISDN BR0/0 Q931: TX -> RELEASE_COMP pd = 8 callref = 0xD6 Cause i = 0x8095 - Call rejected r00583#sh isdn statu Global ISDN Switchtype = basic-net3 ISDN BRI0/0 interface dsl 0, interface ISDN Switchtype = basic-net3 Layer 1 Status: ACTIVE Layer 2 Status: TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED Layer 3 Status: 1 Active Layer 3 Call(s) CCB:callid=8097, sapi=0, ces=1, B-chan=1, calltype=DATA, hdlctype=HDLC-TRUNK Active dsl 0 CCBs = 1 The Free Channel Mask: 0x80000002 Total Allocated ISDN CCBs = 1 r00583#sh int dial 1 Dialer1 is standby mode, line protocol is down Hardware is Unknown Description: Connection to Dardanup Internet address is 192.1.99.98/24 MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, loopback not set Last input never, output never, output hang never Last clearing of "show interface" counters 2w5d Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: priority-list 1 Output queue (queue priority: size/max/drops): high: 0/20/0, medium: 0/40/0, normal: 0/60/0, low: 0/80/0 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes 0 packets output, 0 bytes r00583#sh int dial 2 Dialer2 is up, line protocol is up (spoofing) Hardware is Unknown Description: Connection to Noble St Internet address is 192.168.55.1/24 MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, loopback not set DTR is pulsed for 1 seconds on reset Interface is bound to BR0/0:1 Last input never, output never, output hang never Last clearing of "show interface" counters 2w5d Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: priority-list 2 Output queue (queue priority: size/max/drops): high: 0/20/0, medium: 0/40/0, normal: 0/60/0, low: 0/80/0 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 813321 packets input, 62450943 bytes 885739 packets output, 28010059 bytes Bound to: BRI0/0:1 is up, line protocol is up Hardware is PQUICC BRI MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, LCP Open Open: IPCP, loopback not set idle 00:33:18 Interface is bound to Di2 (Encapsulation PPP) Last input 00:00:02, output 00:00:01, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 5 minute input rate 0 bits/sec, 1 packets/sec 5 minute output rate 0 bits/sec, 1 packets/sec 813353 packets input, 62451535 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 885771 packets output, 28010659 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out 7 carrier transitions r00583#sh run Building configuration... Current configuration : 3580 bytes ! version 12.2 service timestamps debug datetime msec localtime service timestamps log datetime msec localtime service password-encryption service udp-small-servers service tcp-small-servers ! hostname r00583 ! logging queue-limit 100 logging buffered 100000 debugging enable secret 5 $1$xToA$/uHGD43f8GHVL31hy1LG.1 enable password 7 0100050D4F0E051B ! username wp_noble password 7 05080F1C2243 username r00569 password 7 01100F175804 clock timezone WST 8 ip subnet-zero ! ! no ip domain lookup ! no ip bootp server ip audit notify log ip audit po max-events 100 no ftp-server write-enable isdn switch-type basic-net3 ! ! ! ! interface FastEthernet0/0 ip address 10.70.1.254 255.255.0.0 rate-limit input access-group 120 64000 12288 16384 conform-action transmit exceed-action drop rate-limit input access-group 122 64000 12288 16384 conform-action transmit exceed-action drop duplex auto speed auto ! interface Serial0/0 bandwidth 256 no ip address encapsulation frame-relay no ip mroute-cache logging event subif-link-status logging event dlci-status-change priority-group 3 frame-relay lmi-type ansi ! interface Serial0/0.16 point-to-point description access to TPIPS bandwidth 256 ip address 192.168.10.254 255.255.255.0 backup interface Dialer1 no ip mroute-cache no cdp enable frame-relay interface-dlci 16 IETF ! interface BRI0/0 description Connection to Dardanup and Noble ST no ip address encapsulation ppp no ip split-horizon dialer pool-member 1 dialer pool-member 2 isdn switch-type basic-net3 ppp authentication chap ! interface FastEthernet0/1 ip address 203.49.82.177 255.255.255.240 shutdown duplex auto speed auto ! interface Dialer1 description Connection to Dardanup ip address 192.1.99.98 255.255.255.0 encapsulation ppp no ip split-horizon dialer pool 1 dialer remote-name r00569 dialer idle-timeout 300 dialer string 0897262086 dialer hold-queue 10 dialer-group 1 priority-group 1 no cdp enable ppp authentication chap ! interface Dialer2 description Connection to Noble St ip address 192.168.55.1 255.255.255.0 encapsulation ppp no ip split-horizon dialer pool 2 dialer remote-name wp_noble dialer idle-timeout 2000 dialer string 0893532520 dialer hold-queue 10 dialer-group 2 priority-group 2 no cdp enable ppp authentication chap ! router eigrp 1 network 10.0.0.0 network 192.1.99.0 network 192.168.10.0 network 192.168.55.0 no auto-summary no eigrp log-neighbor-changes ! no ip http server ip classless ip route 0.0.0.0 0.0.0.0 192.168.10.1 ip route 0.0.0.0 0.0.0.0 192.1.99.99 200 ip route 10.155.0.0 255.255.0.0 192.1.99.99 200 ip route 10.156.0.0 255.255.0.0 192.168.10.1 ! ! access-list 100 deny eigrp any any access-list 100 permit ip any any access-list 120 permit tcp any any eq smtp access-list 122 permit ip host 10.70.1.1 10.155.0.0 0.0.255.255 dialer-list 1 protocol ip permit dialer-list 2 protocol ip permit priority-list 1 protocol ip high tcp telnet priority-list 1 default low priority-list 2 protocol ip high tcp telnet priority-list 2 default low priority-list 3 protocol ip high tcp telnet priority-list 3 protocol ip medium tcp 1040 priority-list 3 protocol ip medium tcp 2093 priority-list 3 protocol ip medium tcp 2094 priority-list 3 protocol ip medium tcp 2095 priority-list 3 protocol ip medium tcp 2096 priority-list 3 default low snmp-server community public RO snmp-server enable traps tty ! line con 0 line aux 0 transport input all line vty 0 4 password 7 15430E18092F7A2A login length 20 ! ntp clock-period 17180302 ntp server 10.155.1.253 ! ! end