OHCIN_HUGH_2821_VG1#show voice port 0/0/0:0

recEive and transMit Slot is 0, Subslot is 0, Sub-unit is 0, Port is 0
 Type of VoicePort is E&M
 Operation State is DORMANT
 Administrative State is UP
 No Interface Down Failure
 Description is LD T1
 Noise Regeneration is disabled
 Non Linear Processing is enabled
 Non Linear Mute is disabled
 Non Linear Threshold is -21 dB
 Music On Hold Threshold is Set to -38 dBm
 In Gain is Set to 0 dB
 Out Attenuation is Set to 0 dB
 Echo Cancellation is enabled
 Echo Cancellation NLP mute is disabled
 Echo Cancellation NLP threshold is -21 dB
 Echo Cancel Coverage is set to 64 ms
 Echo Cancel worst case ERL is set to 0 dB
 Playout-delay Mode is set to adaptive
 Playout-delay Nominal is set to 60 ms
 Playout-delay Maximum is set to 250 ms
 Playout-delay Minimum mode is set to default, value 40 ms
 Playout-delay Fax is set to 300 ms
 Connection Mode is normal
 Connection Number is not set
 Initial Time Out is set to 10 s
 Interdigit Time Out is set to 10 s
 Call Disconnect Time Out is set to 60 s
 Ringing Time Out is set to 180 s
 Wait Release Time Out is set to 30 s
 Companding Type is u-law
 Rx  A bit no conditioning set
 Rx  B bit no conditioning set
 Rx  C bit no conditioning set
 Rx  D bit no conditioning set
 Tx  A bit no conditioning set
 Tx  B bit no conditioning set
 Tx  C bit no conditioning set
 Tx  D bit no conditioning set
 Rx Seize ABCD bits = 1111 Default pattern
 Rx Idle ABCD bits = 0000 Default pattern
 Tx Seize ABCD bits = 1111 Default pattern
 Tx Idle ABCD bits = 0000 Default pattern
 Ignored Rx ABCD bits =  BCD
 Region Tone is set for US

 Analog Info Follows:
 Currently processing none
 Maintenance Mode Set to None (not in mtc mode)
 Number of signaling protocol errors are 0
 Station name None, Station number None
 Translation profile (Incoming):
 Translation profile (Outgoing):

 Voice card specific Info Follows:
 Operation Type is 2-wire
 E&M Type is 1
 Signal Type is wink-start
 Dial Out Type is dtmf
 In Seizure is inactive
 Out Seizure is inactive
 Digit Duration Timing is set to 100 ms
 InterDigit Duration Timing is set to 100 ms
 Pulse Rate Timing is set to 10 pulses/second
 InterDigit Pulse Duration Timing is set to 750 ms
 Clear Wait Duration Timing is set to 400 ms
 Wink Wait Duration Timing is set to 200 ms
 Wait Wink Duration Timing is set to 1200 ms
 Wink Duration Timing is set to 200 ms
 Delay Start Timing is set to 300 ms
 Delay Duration Timing is set to 2000 ms
 Dial Pulse Min. Delay is set to 140 ms
 Percent Break of Pulse is 60 percent
 Auto Cut-through is disabled
 Dialout Delay is 70 ms
 Hookflash-in Timing is set to 480 ms