I have a few 3560x switches, and some 4500s. The 4500s are connecting to my ACS with RADIUS just fine and authenticating MAB with an internal indentity store. I am using TACACS for command AAA and I am starting RADIUS for MAB. When I configure the 3560X switches for RADIUS, and run a 'debug radius," the 3560 switches don't even attempt to send data to the ACS. TACACS on the 3560x switches works great. I am at a loss as to why the 3560s will not send AAA data at all, but my 4500s are working great. Any incite would be great!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...