Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

802.1x caused Switch to hang - Memory too low

Hi all,

Anyone experienced this before while turning on flex authentication (802.1x, MAB, Web Auth), causing the switch too hang. When the switch hang, I can't even telnet to switch or even console into the switch. The message I am getting from the console is "Memory too low, please try again later".

It happens weeks after 802.1x was enable on the switch, can anyone share their experience on this? Thanks.

Everyone's tags (7)
1 REPLY
New Member

802.1x caused Switch to hang - Memory too low

Any luck with this??

We have quite a few 4500's doing the same thing.

470
Views
0
Helpful
1
Replies