cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
830
Views
0
Helpful
1
Replies

802.1x caused Switch to hang - Memory too low

davidlow8606
Level 1
Level 1

Hi all,

Anyone experienced this before while turning on flex authentication (802.1x, MAB, Web Auth), causing the switch too hang. When the switch hang, I can't even telnet to switch or even console into the switch. The message I am getting from the console is "Memory too low, please try again later".

It happens weeks after 802.1x was enable on the switch, can anyone share their experience on this? Thanks.

1 Reply 1

m-ketchum
Level 1
Level 1

Any luck with this??

We have quite a few 4500's doing the same thing.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: