Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

802.1x on Cisco Catalyst 2960

I am trying to enable 802.1x on one of

the switchports of the Cisco Catalyst

2960:

C2960#sh run | i radius

aaa authentication login test group radius local

aaa authentication dot1x default group radius

radius-server host 10.250.97.26 auth-port 1812 acct-port 1813

radius-server source-ports 1645-1646

radius-server key 123456

C2960#sh run | i dot

aaa authentication dot1x default group radius

dot1x system-auth-control

dot1x guest-vlan supplicant

dot1x critical eapol

C2960#conf t

Enter configuration commands, one per line. End with CNTL/Z.

C2960(config)#int g0/14

C2960(config-if)#dot1x ?

% Unrecognized command

C2960(config-if)#dot1x

As you can see, I can not enable 802.1x

at the interface level. The code is am running is 12.2.25SEE4:

Switch Ports Model SW Version SW Image

------ ----- ----- ---------- ----------

* 1 24 WS-C2960G-24TC-L 12.2(25)SEE4 C2960-LANBASEK9-M

System image file is "flash:c2960-lanbasek9-mz.122-25.SEE4.bin"

According to Cisco, this image supports

802.1x. Why can't enable it at the

interface level?

Can someone help me out? Thanks.

4 REPLIES
Silver

Re: 802.1x on Cisco Catalyst 2960

some additional info:

C2960#sh dot1x all

Sysauthcontrol Enabled

Dot1x Protocol Version 2

Critical Recovery Delay 100

Critical EAPOL Enabled

C2960#

Hall of Fame Super Blue

Re: 802.1x on Cisco Catalyst 2960

Hi

Before typing dot1x under interface try

C2960(config)#int g0/14

C2960(config-if)# switchport mode access

C2960(config-if)# dot1x ?

Jon

New Member

Re: 802.1x on Cisco Catalyst 2960

This works only if switchport is access port. So configure switchport mode access.

Re: 802.1x on Cisco Catalyst 2960

You must input "swithport mode access" first, then you can input 802.1x cmd.

Regards,

~JG

Do rate helpful posts

2341
Views
0
Helpful
4
Replies
CreatePlease login to create content