Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

802.1x on wired LAN with ACS 4.2

Hi all,

            I am trying to get 802.1x fully working in our LAN. I get it working in lab test for all the PC,but we using IP phones which are not cisco and do not support 802.1x Authentication. I wanted to using MAC bypass for these phone;however, it seems the 2950T with EI image does not have mab and pae commands under in the terface command! I did upgrade the IOS from c2950-i6q4l2-mz.121-22.EA6.bin to c2950-i6q4l2-mz.121-22.EA12.bin with no LUCK!

And I want to deny access to switch port behind these phones as I already have two cable drop for each office and cubicle. The only way that i can block these ports is  to use port-security and  hardcoded the MAC of each phone and set the mac-max=1. To reduce IT intervention, I don't want to go down this road. Is there a way to acomplish that?

Thanks,

---Jean Paul

269
Views
0
Helpful
0
Replies
CreatePlease to create content