Re: 802.1x problems with Cat4510E-Sup6L, IOS 12.2.54
Hi, I have experiensed a similar problem, I have a C4506 sup 4, with gig interfaces. I have ACS5.1 and if I enable dot1X on a access-port it works fine in multi-host mode but when I switch to multi-domain it stops working, the pc and phone gets an IP address but they are not able to communicate, not even pinging the default GW. Directiy after the switch to multi-domain (from multi-host) the phone and pc works but if i do a shut no shut on the interface it stops working. I have logged a case with TAC and wating for an answer. I run the latest release 12.2(54)
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...