Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

802.1x windows group policy

We have strange issue , some users disconnected and connected again within few seconds.

which result Cisco NAC agent started again to check posture status , but no logs on the switch that the ports were down also IP Phones connected between switch and PC.

we noticed that there is group policy pushed from Domain in the same time.

any one faced this issue (when apply group policy , the network card reset?)

4 REPLIES
New Member

I tested the COA action

I tested the COA action "session termination" and it made the same symptom.

how can I confirm that this is not "session termination initiated from ISE" .

Cisco Employee

Disconnecting the PC should

Disconnecting the PC should generate a disconnect message to the switch. Please provide:

1. Make and model of the phone

2. Type of device connecting to it and OS running on it

3. Make and model of the switch

4. Port configuration

 

Thank you for rating helpful posts!

Thank you for rating helpful posts!
New Member

1- CP-79452- Windows 8.1.3-

1- CP-7945

2- Windows 8.1.

3- WS-C3750X-24P.

4- 
 switchport mode access
 switchport voice vlan x
 ip arp inspection limit rate x
 authentication event fail action next-method
 authentication event server dead action reinitialize vlan x
 authentication event server dead action authorize voice
 authentication host-mode multi-domain
 authentication order dot1x mab
 authentication priority dot1x mab
 authentication port-control auto
 authentication timer reauthenticate server
 mab
 snmp trap mac-notification change added
 snmp trap mac-notification change removed
 dot1x pae authenticator
 dot1x timeout tx-period 12
 spanning-tree portfast
 ip verify source

New Member

I also found the below log in

I also found the below log in event viewer of the machine:

A newly downloaded Wired Group Policy was applied to your computer.

Wired Group Policy Name: 802.1x.
Applied settings:
    AutoConfig Enabled: Yes
Wired Group Policy Summary
    Profile applied:   Yes
    Reason Code:   0

211
Views
0
Helpful
4
Replies