My Scenary is that I have configured 802.1X in Cisco Swithches C3750/C3560/C2960, I configured 802.1x in the all Switches, but i have 100 IP Phone Nortel with 2 ports one port connected to Switch and the other port connected to PC. I know that IP Phone Cisco work in the enviroment 802.1X, this feature i can configurate enable Radius (Cisco IOS/PIX 6.0) and in the group i have setup in the tab "[009\001] cisco-av-pairbut" put "device-traffic-class=voice" and in the tab IP Assignment i put "Assigned from AAA Client pool" in the case of Nortel how i do? is similar?? i have to setup in the "[009\001] cisco-av-pairbut" the same way??? and i've seen a configuration with cisco in the link:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...