Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

%AAA-6-USER_BLOCKED: Enable view requires to be authenticated by non-none methods,Please use the appropriate method with the login authentication

Hi guys,

I am doing some basic VIEW config with Cisco ACS 4.2 and I've had a issue below:

1. %AAA-6-USER_BLOCKED: Enable view requires to  be authenticated by non-none methods,Please use the appropriate method with the  login authentication

None method authentication is not allowed in CLI

Recommended  Action: Copy the message exactly as it appears on the console or in the  system log. Research and attempt to resolve the issue using the tools and  utilities provided at http://www.cisco.com/tac . With some messages, these tools and  utilities will supply clarifying information. Search for resolved software  issues using the Bug Toolkit at http://www.cisco.com/cgi-bin/Support/Bugtool/launch_bugtool.pl .  If you still require assistance, open a case with the Technical Assistance  Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create , or contact  your Cisco technical support representative and provide the representative with  the information that you have gathered. Attach the following information to your  case in nonzipped, plain-text (.txt) format: the output of the show logging and show  tech-support commands and your pertinent troubleshooting  logs.

Related documents- No specific documents apply to this error  message.

Anybody has been seen and fixed it before? thank you so much.

Regards,

Tran

2 REPLIES
Cisco Employee

Re: %AAA-6-USER_BLOCKED: Enable view requires to be authenticate

Hi can you share with us your AAA configuration section on the AAA device (switch/router)?

What is the Radius server you are using?

Thanks,

Tiago

--

If this answers your question please mark the question as "answered" and rate it, so other users can easily find it.

New Member

%AAA-6-USER_BLOCKED: Enable view requires to be authenticated by

Hi Tran,

For the parser view to work, you need to do the authentication default local in the aaa.

Then try authenticating again.

Use the local enable password.

U'll surely get the output as:

*Nov 27 11:03:49.917: %PARSER-6-VIEW_SWITCH: successfully set to view 'root'.

Config is as follows:

enable password cisco

aaa new-model

aaa authentication login default local

-------------------------------

Router#enable view

Password:

Router#

*Nov 27 11:03:49.917: %PARSER-6-VIEW_SWITCH: successfully set to view 'root'.

Router#

-----------------------------------

Then once the view has been created, you can work and change accordingly the aaa-authentication and everything as per need.

972
Views
0
Helpful
2
Replies
CreatePlease login to create content