I am configuring aaa accounting on a Catalyst 3750 running 12.2(25)SEE, but not have the wait-start option; I only have start-stop and stop-only. So I go to univercd and the wait-start option is in the IOS documentation for 12.0 and prior, but does not show up in documentation for 12.1 and beyond. I cannot find any evidence, however, that the option was removed in any documentation that I have found. So I use start-stop and continue configuring on other devices. Then, I get to a Cisco 2621 router running 12.2(5d), and it does have the wait-start option. Any ideas why it would be available on one and not the other? Is it a router/switch thing? Also, any idea why it disappears from the IOS documentation at version 12.1 and up, even though it shows as an option on a router with 12.2? Thanks.